The conspicuity system shall be installed and located as specified in FMVSS No. 108 (S5.7.2), or a combination of retroreflective sheeting and reflex reflectors that meet the requirements of FMVSS No. 108 (S5.7.1), reflex reflectors that meet the requirements FMVSS No. Each trailer of 2,032 mm (80 inches) or more overall width, and with a GVWR over 4,536 kg (10,000 pounds), manufactured on or after December 1, 1993, except pole trailers and trailers designed exclusively for living or office use, shall be equipped with either retroreflective sheeting that meets the requirements of FMVSS No. (ii) The conspicuity material when installed on the motor vehicle meets the visibility requirements for the reflex reflectors. (i) The conspicuity material is placed at the locations where reflex reflectors are required by Table 1 and Trailers which are equipped with conspicuity material which meets the requirements of ยง 393.11(b) are not required to be equipped with the reflex reflectors listed in Table 1 if. (2) Exceptions: Pole trailers and trailer converter dollies must meet the part 393 requirements for lamps, reflective devices and electrical equipment in effect at the time of manufacture. Commercial motor vehicles manufactured before December 25, 1968, must, at a minimum, meet the requirements of subpart B of part 393 in effect at the time of manufacture. 108) in effect at the time of manufacture of the vehicle. All commercial motor vehicles manufactured on or after December 25, 1968, must, at a minimum, meet the applicable requirements of 49 CFR 571.108 (FMVSS No. The diagrams in this section illustrate the position of the lamps, reflective devices and associated equipment specified in Table 1. Table 1 specifies the requirements for lamps, reflective devices and associated equipment by the type of commercial motor vehicle.
0 Comments
Leave a Reply. |